Quality Standards and Environmental Certifications
×
×

Form Unavailable

In accordance with your Cookie preferences this form is not currently available. Should you wish to make a submission please allow Performance cookies to run in your browser session. You can access and change your preferences via the Cookie Settings button below or through our Footer link ‘Cookie Notice’ > ‘Cookie Settings’. If you still have issues seeing the form after accepting cookies please try and clear your local cookies and reload the page and accept the Performance cookies again.

New Three-phase MOSFET Driver IC with On-board Regulator

January 02, 2018
A4919 Product Image

Used to Supply both Sensors and Microprocessor Power

Allegro MicroSystems, LLC announces a new three-phase MOSFET driver IC with an integrated low dropout regulator supplying 5 V or 3.3 V. Allegro’s A4919 is designed for a wide range of industrial applications. It can be controlled with block (trapezoidal), sinusoidal, or vector commutation when interfaced with a microprocessor. The A4919 is designed to be a simple direct control gate driver for both the commercial and industrial markets providing LDO for peripherals or a microprocessor and provide complete flexibility over commutation.

A unique charge pump regulator provides full (>10 V) gate drive at power supply voltages down to 7 V and allows the A4919 to operate with reduced gate drive at power supply voltages down to 5.5 V. A bootstrap capacitor is used to provide the above power supply voltage required for the high side N-channel MOSFETs. One logic-level input is provided for each of the six power MOSFETs in the three-phase bridge, allowing motors to be driven with any commutation scheme defined by an external controller. The power MOSFETs are protected from cross-conduction by integrated crossover control.

Motor phase short-to-supply and short-to-ground detection is provided by independent drain-source voltage monitors on each MOSFET. Short faults, supply undervoltage, and chip overtemperature conditions are indicated by a single open-drain fault output. Product variants include either 5.0 V or 3.3 V LDO or an option without LDO and instead provides a voltage input which can be used to monitor an external voltage source.

The A4919 is supplied in a 28-pin TSSOP power package (package type LP) and a 28-terminal 5 mm × 5 mm × 0.90 mm (QFN package) both with an exposed pad for enhanced thermal performance. Both packages are lead (Pb) free, with 100% matte-tin leadframe plating (suffix T).

Please click here to download a copy of A4919 three-phase MOSFET driver IC datasheet.